开云体育

Well got the top and bottom locknuts from Felder. Tried the spindle and bearings don’t seem to be getting hot but I have an issue with the belt. In another thread where the issues with the spindle

yep, I know the math going from metric to imperial ( I was not leading the team that crashed the Mars Climate Orbiter), just did not realize the unit was not converting for me. my bad. The Italians,

I guess I should have stated that, two decimal places in metric means three in inches, so you do have your .001” resolution. If you set it in metric to one decimal place you get tenths of a mm or

no, i just wanted readout to the nearest .001". Probably would have been ok with plus/minus .005", which, by my count, is 3 decimal places. if operating in mm, which i generally do not, then of course

Hi Taylor, I tried Ali Express for electrical components and got junk. You may get lucky or not. I personally would buy used in USA (from electrical salvage retailers) before resorting to Aliexpress.

of course! Its just 2 aliexpress parts. The contactor seems to be out of stock now but its just a generic part.

You want 3 or 4 decimal places? The banding is not capable of that sort of accuracy, as it is you can get down to .0004” with it set on metric and two decimals. You would need a different banding

Thanks Brian and Cliff! Looks like setting decimal places to 2 and otherwise operating in “preset” mode works well enough. I've found that setting the number of decimal places to 4 or 3 causes

I agree mac that wiring on the outside of a wall can be a beautiful thing...here are some pictures from my shop.

maybe this? https://www.youtube.com/watch?v=A01CrX0ytUk

Thanks Brett. I do have two 220mm rebate heads to do the tongue with but thought I try this cutter. My low range 3 pc. adj. groover (IIRC 4-15 mm) does not have the T & G feature because the outside

If you have the spacers and the time to figure out the cutter overhang from the body, make it a rebate cutter and really maximize your utility on investment haha. Seriously though just using it as a

Hi Joe, You only have to access the parameters once, so typing in 273 isn’t that big of a deal. “ouEr” means you have lost signal from the magnetic banding, will definitely happen when not in

Awesome. If you don’t mind please share the parts you used. May be helpful for someone following you in this quest ? Imran

I think what I intend to do is okay but I rather be safe than sorry. I have this CMT set and was going to use it for the first time for making a 1/4” tongue on the long side of 3/4” boards.

Yeah i opened it and there are only the 3 phases and a ground wire. I managed to get a hold of an electrician who will hook it up for me when the contactor and wireless board arrive. I really

Hi all, sounds like a few of you have a great deal of experience with these units so wanted to get tips.? I just installed an F7 on the rip fence of my Hammer K3.? that went smoothly.? using this

Wow, not much happening in there, Lol. I don’t know of any reason why you would have neutral connected anywhere. Disconnect cable, open the switch box and check. Should only have 3 phase wires and

They Look Great ! That should be an easy sell

Thank you a lot, Imran! This is very heplful. I know all 3 phase cables have the 5 wires in them here. the 3 phases, ground and neutral. The af22 just has a regular male CE 3 phase plug on where i