开云体育

One nice things about a french cleat is that the thing hanging on the cleat can be leveled by placing shims between the halves of the cleat. We hang a lot of art work with french cleats. Also, most of

Looking for advices, I am building floating (not touching the floor) lower closet cabinets and plan to put a hardwood panel glue-up on top. The assembly will be located in a recessed area and bumped

David, The easy glide is a step up. My Profile shaper had easy glide but the spindle position was controlled by motors so I don’t have a direct comparison of hand wheel to hand wheel from old

David, That makes perfect sense. There is brick, on the wall, where this is going. I know the guy whose house it is going in but I am primarily helping my neighbor who decided to take up this

And then there is the occasional young kid or an old young at heart kid that wants to hang from the floating mantle ???? Imran

This KF700 has a double trunion - not the single trunion from the pre-2004 era Brian is talking about. What it does not have is the new EasyGlide (Delrin) runners in the trunion, so it requires lube

Yea, if you did that you’d have to sheetrock down to the mantle after. In the case I was working on, we had gone back to the studs throughout the house, installed the brackets (for the mantle and a

The screws from the top stop the inevitable person that bumps “up” into it from knocking it off the dang wall (ask my how I know). If you’re SURE nobody will bump it from below, they will. My

A little math, and envisioning of the physics can also be useful.? Your mantle timber weighs about 130 pounds (2.8 cu ft x 45#/cu ft). Assuming studs on 16" centers, you'll have three studs to attach

Mike, You made the right call in my opinion. The price being demanded is for a pristine machine with everything in excellent working order. Having said that, I have 2002 KF700 and no issues with

When looking at any machine that hangs the guts from the cast iron table, you want to put a straight edge across near the opening to look for any depression in the top. Beefing up the casting is

Thanks Brian for your description. I'm sure that the older trunnion may be just fine, but it does require more cleaning, lubrication and perhaps fussing with adjustments. ?That being said both saws

Brian, I know that but I was wondering what Mike thought. I ran 40 pound cutters on the year 2000 F700z I had with single trunnion and it worked. Hansjorg Felder told me the single trunnion was strong

I've done similar shelf installation down and dirty with lag screws into the studs. Once driven, the heads were cut off, and holes bore in the back of the shelves with an auger bit. Squirt some PL

David, Thanks for the details. I guess if I were to do this, i will probably epoxy the brackets in the mantle and then bolt the verticals to the studs while keeping mantle level. This on account of my

The older machines have a single trunnion affair and it supports the whole spindle and motor system on one end of the assembly. This brings into account an adjustment nightmare dealing with “angle

Mike, What are the Trunion issues? Joe

For what it’s worth, this is a lot of clamps, lots of “bouncing” load like 16” out. 2 cabinet mounting screws into the studs, 3/4” French cleat. Not sure what they’re doing on the mantle

Mark, Can you give us more colors about your reasoning of virtually going T60 instead of K940, or even T60 instead of Kappa 400 (basic no X motion). Price wise, as far as I know, a T60 with DRO is

Mike, I would remain patient with the seller. I think in time he will sell to you. Sometimes you need to let people test the market and become frustrated/educated on reality. What trunnion issue? Do