开云体育

I'm not sure if it's because of the times (covid) or what, but I have been watching the auction sites and witnessed 8 original signed by Sam,? Maloof chairs sell for a merely $14,000 for all 8.?

Brian, if you want a solid rip fence DRO solution check this out. not sure how adaptable it will be for hammer. https://youtu.be/Y4BU1pLqTmU Imran

Steve, I do spend some time on Sawmill Creek (I'm a Contributor), but didn't see anything recently.? I'll do a search and see what I can find.? I appeciate your comments, there are times when the

Hi Mikkel, Sure I can give you my experience of a couple of months.? Some of it may be user error on my part as I didn't install it and don't have the instructions from Wixey. (I need to go to their

Hi Imran, Thanks for the suggestion, I'll check out the Shark website.? I would like to get good dust collection off the blade, I just have to figure out how to collect it.? I'm running a 5" hose to

That appears to be an older Aluminum fence housing. Brian Lamb blamb11@... www.lambtoolworks.com

I had no idea this saw came with support legs either. It was never mentioned by the salesperson. Good point on not being able to pull downward with the support leg, only push upward. So I guess I will

There was a Kundig version of your edge sander. Unique ? Dave ________________________________ Sent: Wednesday, December 16, 2020 3:40 PM To: [email protected] <[email protected]>

I have a Felder CF-741 professional combo machine near San Luis Obispo. It was purchased new in 2002 and used by a hobbyist. Please email for details if you are interested. redwoodcoaster@...

Yes, the longest slider with the K500 comes with it. Not sure how useful it is, but I put them on my saw. Bill

Of course a work from a Master can increase in value after his death. More often than not in the painting works. A painting by van Gogh wasn’t expensive in his lifetime , but now you can’t touch

Mark, The plate is held by 2 screws. i assume it also helps to keep the housing tight against the round bar so that it slides smoothly. if your machine was newer it might be different. Imran

I had no idea that K500 uses support legs on the slider base extrusion. I assume this is for longer sliders only. Imran

A $20 iron vs. a $15,000 laser? Not sure I’d call that cheaper... Brian Lamb blamb11@... www.lambtoolworks.com

Brian, Here is the micro adjust on KF700. Brass pin to lock the C shape part onto the round tube. and parts diagram shows the detail. from your description sounds similar to Hammer. Assuming, hammer

Thought I had adjusted mine some how, i was having the same behavior Regards, Mark https://www.instagram.com/kessler_woodworks/

My KF700 is 2002. Here is the rip fence locking detail no adjustment. the plate is just pushed in and it clamps on the round bar. someone may have just guided me to not push it all the way. never had

Wow, I lust after that machine but I don’t have enough dust collection to run a 43” triple head. Probably fine with a double 37” Sent: Wednesday, December 16, 2020 1:38 PM To:

No, what are they selling? Sent: Wednesday, December 16, 2020 1:23 PM To: [email protected] Subject: Re: [FOG] Thoughts on going from K500 P to K700 S Joe, did you see the sander on Woodweb

Joe, did you see the sander on Woodweb from 360? dave ________________________________ Sent: Wednesday, December 16, 2020 3:08 PM To: [email protected] <[email protected]> Subject: