开云体育

Paul, So close! Come and buy all my stuff and the building! $2.2 million. Joe in New Orleans

Tom, To avoid buying an expensive Air compressor with dryer system and pneumatic pump to use to spray I bought the Graco Finish Pro 395 air assisted airless sprayer. It is an electric pump with a

it is funny you mention the stuck relief valve. yesterday i used my baby california air 1 gal to air up the tires. as i picked it up and walked around i almost crapped due to a sudden large noise. i

oh, forgot to add, use mill jacks under the unsupported ends sticking out of the vise to quiet down the chatter. Brian Lamb blamb11@... www.lambtoolworks.com

Looks great! If you can mill that, you can make the mounting plates for the trucks. All linear rails are metric, 12mm, 15mm, 20mm, 25mm and up. Brian Lamb blamb11@... www.lambtoolworks.com

Great location, between Valence and Cadiz. What is the asking price for the building? Paul in Metairie

That's pretty cool, Ronnie! Thanks for sharing -- that pivot looks awesome and a neat idea to fix to the wall. If I add a pivot, it would be an iteration of your design.?There are a lot of people who

That was my problem, I forgot…. loved that it was quiet… but never had any other compressor that would cause that sort of problem. Brian Lamb blamb11@... www.lambtoolworks.com

Brian, good to know on the cal air I have a small 10 gal and it is pretty quiet. I turn it off everytime I leave the shop except when I forget... Regards, Mark

Hi Tom, Better air is easy to accomplish with a dryer and then a filter, the compressor is really not the problem. What is the CFM of your current Quincy? A larger storage tank might be all that is

Brian, I’m in the process of expanding my basement shop and I thought it would be a good idea to upgrade my compressor. I have to admit that the Kaeser brochure ?is very good and I liked the idea

And I’m pretty sure you void the warranty if you change the oil and filters yourself, not that it can’t be done, you just loose the warranty. Last I heard was $600 or more for normal maintenance.

There are other brands than 8020, I keep seeing a guy selling surplus here on Craig’s List and it’s pretty cheap, although limited in choices for size. Brian Lamb blamb11@...

Linear rails bolt right into the slots on 8020, so very little fabricating/drilling. Brian Lamb blamb11@... www.lambtoolworks.com

I know a few machine shop guys running that compressor with good success. It makes a load hissing noise when it unloads and stops, that’s been the major complaint. Brian Lamb blamb11@...

What do you plan to run with air? Too open ended of a question without some idea of what you want to do. Brian Lamb blamb11@... www.lambtoolworks.com

Yes, you have to have air flow around the compressor and the electric motor. Brian Lamb blamb11@... www.lambtoolworks.com

I've seen the noise issue mentioned several times but plumbing the intake out side only once.? So I will repeat. It helps.? It and can be easy too if near an exterior wall that is not near a

I purchased a Saylor-Beall 80gal/5HP about 6 years ago and it has been great. ?The low RPM, 2 stage is a litter quite too. -Joe

I did this setup a few years back w/ 8020 but mine was bolted to the wall over the K3. Not to long ago I've taken it down to fit my ShopSabre Pro404 in its place and yet to reinstall it. Basically had