开云体育

Ron, When you are talking about adjusting toe in-out, are you referring to drift? Jason Holtz J. Holtz Furniture 3307 Snelling Ave. South Minneapolis, MN 55406 612.432.2765

Hi Ron, try adjusting the flat bars bolted to the sides of the table. I bet if you check they aren't parallel to the top of the table. Regards, Rod.

OK, the nylon nuts adjust so it rests level to the table, also, you can jack up/down the far end to get your fence level to the table. If those set screws go into the slot and hit the steel bar,

The set screws protrude through alright - but they go through the slot in the fence and hit nut (long metal bar) that holds the fence to the knuckle. A Felder tech was in the Seattle area and stopped

I've had a FB610 for over a year and noticed the same issue with the fence being out of square with the table. Adjusting the white colored hex bolts that Brian has pointed out corrected most of the

Michael and Imran, Thanks for the suggestions. I will clean the rails, and also see if moving the slider clears the issue. I will also pay attention to the saw cover to see if there is a correlation

Hi John, I recently commissioned a KF700 and it had the intermittent start issue. It went away with cleaning the slider parts used to send the electrical signal to/from switches on the slider. You may

The picture posted shows the adjustment for square. The circled hex nuts are to make sure there is no rock or twist in the knuckle when it is clamped to the bar and resting on the table surface. Then

It wouldn't be surprised if there were say, one or two degrees intentionally biased, regarding the face of the knuckle casting, in order to keep the extrusion flat on the table, when it's cinched

Hi John, Congrats on the new machine. I was in line to get the Kappa 450 x after initially ordering a Kappa 400. But due to pricing changes and complications in my time line I've actually ended up

Hi Ron, I have a FB610 and had a look at my fence. The set screws only seem to allow alignment of the fence to be parallel to the blade (or adjust the fence for drift). However, I believe that the

David, my wife calls me a “gadget guy” because I love gadgets and gizmos. I will be happy to share experiences with this system as I figure it out. The PCS is “only” $7,500, not $10,000, by

You may need different backing plates. I have Aigner fence plates ordered with my 2009 KF700SP and I had to get different backing plates to fit the plates to a 2017 700 series shaper.

Well, this should be easy. REALLY easy. Release the 230 hood clamps, slide old fences off, slide on new fences, smile and get back to work. Wrong. I can get the fences to the point of sitting flat on

Analog Felder DIO all but one steel case $55 each shipping included contact off the fog Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell

?I have 10 high speed steel 310 6-2 hole 310 Older style 4 - carbon steel all in nice shape looks like 1 edge new 2 hole new 130.00 takes all shipping us included in USA Pay Pal only Contact off fog

Post some picture of this knuckle. I don't know where the four set screws you mention are located, but on my rip fence for the saw which has a similar casting, you can adjust two set screws on the

The milled surfaces that the fence gets fixed to is not milled square relative to the surface that rests on the flat bar. I contend that this is the critical relationship that is not being maintained

The following items have been added to the Files area of the [email protected] group. * /For Sale/FOG_CF741S_for sale.pdf (

Hi Mike,? Thanks for the offer. Really appreciate it.