开云体育

Ask him for the form I got from Wurth for a reduced sales tax rate in CA for machinery... I am amazed that Felder does not offer it... PK

So apprrently the 3-phase (5.5kW) saw together with a longer bed (3.2m vs 2.8m) and the overhead dust costs less than buying the single phase saw and adding the overhead dust port. I think I'll go to

Just FYI, the capacitors are easy to replace and will set you back about $100 every 5 to 10 years if you don’t have the bank (money or available power, lol) to add a phase converter.

That’s terrible! If I lived where that was a possibility, I would have this on my water

That’s shocking bad. I think about getting a leak in the roof or something, but nothing like what you just described. I feel for you! Warm regards, Lucky Dr David Luckensmeyer From:

A water line burst and the water flood brought down about 20 percent of the ceiling of my and may have been 2 inches deep before I could turn off the water, based on the stains on the walls. The shop

Thanks David. I figured you and Dan jumped later in the conversation and missed the fact that I don’t have powerdrive on K975. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Imran, here is a photo of the control panel on my K975 FYI: ? David Best DBestWorkshop@... https://www.flickr.com/photos/davidpbest/collections/ https://www.youtube.com/@David_Best

Hi Dan, You may not have read earlier msgs. The discussion is about only having the electronic height control and NOT having full powerdrive. I mentioned earlier, that this is implemented on my saw

I probably won't have enough amp in my breaker box for a huge Phase Perfect. I alreay have a 60A circuit for a car charger. 50A for a range 30A for the AC 30A for electric dryer And the shop

Aaron, Not sure how to take the deep pockets comment *;-)* but this is my only hobby and soon it will, fingers crossed,? drive some income for us too.? We bought the home new and have been here for

As far as I know, powerdrive K2 refers to height and angle control, K1 would be for height only. Here’s a short video showing the operation. The spring loaded switch gets you close to where you want

+1 Alpine Workshop as first/next step

If this is your first time using a spindle moulder a 4" head is not what I would start with. Big heads can be quite intimidating when they start up, recommend two pairs of underpants and definitely a

Yes, I have a power feeder! :-)

My comments only to be used with powerfeeder. Eric Stevenson oldy but goody martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

If Shmidit is supplier ask them to make a split cutter 3, 2” or 4” 6” you can use separate or use together, Assume you’re talking 60 degree corrugations. You can have 1/2” wider than

I looked into converting to 3-phase in my hobby shop last year and I really wish I could have done it.? Ultimately, it would have been too costly.? I estimated that it would be probably a $15k

Fair point. Regarding seperate wiring, I am anyway need to run a new electric outlet for the saw, so running from the panel directly to the

Hi, when you say "insert head" are you meaning a corrugated head that takes steel knives that can be custom ground? If you are new to a shaper I will suggest taking a course like Joe's if at all