开云体育

Mike, if you sweet talk Kyle, he will special order you a feeder in a nice neutral grey instead of the s**t-brindle-brown. Here’s mine: David Best

Imran, I have two of those - they are great for grooving drawer bottoms and the like, but not good for joinery. David Best https://www.flickr.com/photos/davidpbest/collections/

That’s a nice blade. I want that blade! Warm regards, Lucky Dr David Luckensmeyer ________________________________ Sent: Friday, March 18, 2022 12:49:56 PM To: [email protected]

I had Leitz custom grind one of their standard blades specifically for joinery work. I believe the up-charge was about $25 over the cost of the new blade which was about $130. I recommend you call

After having the Felder option for years collecting dust it has become quite useful this past week in combination with Brian’s version and the less talked about Lamb Toolworks fence digital stop.

Well that got more attention than anticipated. 1. Yes the slider will lock in 2 positions if the arrows are nicely lined up. Like threading a needle. 2. The red stripe is a reminder to not wrap my

Aren't all rip blades FTG? That said, as in Lucky's example above, I recently sent of the combination blade that came with my (you should pardon the expression) SawStop to be ground flat at 10 degrees

I bought a Leitz from my local saw sharpening shop and he reground it so it cuts a true flat bottom. I use it for fine detail hardwood joint work. Mark Foster

Hello John, Here is one of Freud's offerings:

Imran i have that one, good for just plowing a groove but i didn’t like it for joinery like a bridal joint. The Freud I bought (link below) is really good for that. Regards, Mark

Felder offers this (currently out of stock) with 4mm kerf. https://www.felder-group.com/en-us/shop/slotting-saw-blades-sc91893/hw-slotting-saw-blade-silent-power-with-solid-tool-body-sp91897 Imran

Yes you can have it re-bored, i have also had an atb reground at one point in the past. Here is one i recently bought but i think it’s a thin kerf.

John, do you have a Leitz rep in your area? Leitz have an enormous catalog of tooling and I’ve bought several blades from them which are “blanks” in that the carbide teeth are flat, ready for

I have been looking for an FTG blade, but they are not easy to find. This would be primarily for flat-bottom cuts. I bought a couple of Tenryu blades, but they do not offer a flat-tooth option with

You should also consider your selling motivation/strategy. For example, your Hammer A3/41 will sell in a heartbeat if your price is 'reasonable'. That's fine if you want to just get rid of stress

That I wouldn’t know, best to ask Felder that question. Brian Lamb blamb11@... www.lambtoolworks.com

Mike, It may be different on your saw but besides std locking position I can also lock when the slider is fully out, as it would be for loading a sheet. It may not be the intended use but the Locking

Now I understand what I am looking at ? I appreciate you fellows staying with me until I figured it out. I suspect the screws holding the eccentric posts in place were installed with thread lock

Mike, I see the slider lock lever adjacent to the table in your picture. Locate the two arrows on the slider and base and flip the lever inward. Bill Belanger

Hello Bill, I wish you a happy and healthy retirement. I have a Felder saw on order, I would be interested in any blades, groover/ dado or other saw accessories. Also....a dust collector and piping/