开云体育

Yep, I have the larger version of that, 20” I think it is. Added a VFD to the motor and now I rarely used the Reeves drive to adjust speed. They tend to gum up in the dusty wood shop, or at least

Same concern. Strange design.

I have a rebuilt Powermatic from the 1970's.? I like the variable speed aspect of it, and since it's a 50-year-old machine, there's no plastic.? Built like a tank.

It looks like you have still a few years to figure that out.? My kids were and are always welcome in the shop and as teenagers are now able to operate many machines.? But that is a slow

Hi Tom, I have mine mounted solid to the v-blocks without any shims. I re-aligned my machine for toe out of the rip fence to the blade and slider to the blade a year or so after I got it in 2001. Have

Stan, Claudio has go it right. Teach hand tools and how they work have them build a project with them like a mallet then show how the machine works as a more efficient way of the hand tool to get it

I have a SawStop and a Hammer C3 (and also a SCM si400 slider).? There is no comparison in a "bolt on" slider to a true format slider. For your smaller shop, maybe a Hammer slider?? It would cost

Thanks Jason, thats what i will be using for my veneer work from now on.. Don’t know why though, I did say that I never had issues with the t2… Regards, Mark

That’s the only thing I can see or the small axel shaft has a bend in it.

I would approach this very differently. I think kids should learn to use hand tools first to learn about wood, grain, etc. Start off with a spokeshave making shavings, and eventually making things

Yes I use it on shop sawn veneers also. I get almost no bleed through on most commercial veneers. Jason Holtz J. Holtz Furniture www.jholtz.com 3307 Snelling Ave. South Minneapolis, MN 55406 612

Thinking about it now I think to get it less bumpy I focused on getting it flush just where the roller was, mine had a slight twist to it so i needed to tilt down on the far right end otherwise the

My older machine has a plastic pad with a large radius on the bottom rather than a wheel. Wonder if they could mount two rollers in tandem so that why one is over the table joint the other supports.

Thank you.

My K975 has set screws (I think that’s what Mark Kessler K940 might be like) to adjust the height of sheet metal extension table. I got it perfectly level with the cast iron. Still has the rolled

I like the table… well done! Brian Lamb blamb11@... www.lambtoolworks.com

Wade, If you still get that thud more than once, maybe the nylon support wheel is not round ? James

Thank you all for the feedback. I am looking for general glue for edge gluing. I intend to get into laminating and veneering soon. Read about TB3 not good for veneering on WoodWeb many yrs ago. IIRC,

Jason, Interesting comment on the Unibond. I’ve been talking to Darryl about my upcoming curved lamination project and am going with his gear (and GLUE! The 800). WRT Titebond. For cabinet work

Yes, I get that sound only during the transition between the cast top and the steel top. James