开云体育

Thanks Brian, that notched version is exactly what I needed. Thanks! BB

Here are some pictures: Thanks, Bill

Thanks Brian, Yes the picture I show is mirrored and I was hoping someone had the file in the correct orientation. It's not the original file in the files section, but one that I was starting to

Take some pictures of the fence housing on the bar so we can see what sort of room and position you need. Shouldn’t be hard to come up with something. Brian Lamb blamb11@...

Bill, I created a notched version and loaded it on the website. See if that works for you. Brian Lamb blamb11@... www.lambtoolworks.com

Thanks, After having cut the parts, drill holes in the housing fence, I realized that the fence is way way too small to use machine screws from inside to outside. Also the fence housing is way too

I have the STL, but it’s opposite the way you show. Did you by chance mirror image the file at some point? Worst case, tell me how thick and wide the notch you want cut out of it and I’ll do it

Thanks so much David. Nice stuff! What I was looking for was an STL file that I could print in nylon. Bill Bélanger <david@...> wrote:

https://www.flickr.com/gp/davidpbest/ZoC3b6 David Best - via mobile phone

In looking at the 3D files, I find a DRO version of a fence attachment. I'm trying to redesign it to fit my Kappa 400 fence, but maybe someone else has already done this? The post is on the wrong side

You don’t have to use the cover strip, but it does protect the soft magnetic layer. I would use it. Brian Lamb blamb11@... www.lambtoolworks.com

Stupid question about the magnetic strip, The product comes with two strips, one thick that is supposed to the magnetic strip and one thin that is supposed to be a cover strip for protection. I guess

Massive, yes. I feel sorry for the hinges ;-) Cheers Eric

Thanks Tim. Will share when done. Wife excepts it finished by May. Will see, I have my doubts. Imran On Dec 30, 2021, at 12:52 PM, Tim House <casabueno@...> wrote:

Nice project! Those "square cuts" certainly assist on the glue up and joint fit. Please post a photo of the completed door(s). Tim House [email protected]> wrote:

Joinery detail

?Well massive for my hobby shop anyways. Two of my long flattest surfaces in the shop (10’ slider and 9.5’ jointer w/ext tables) in use for glueup of first door panel - 148” x 72”. Just used

Thanks David, I’ll revisit the leveling and the toe-out, and I understand that the slider is otherwise about as good as it is going to get. Cheers, Roger

Nevin, When this happened on my Hammer, the tech instructed me to tilt the blade to 45 degrees to facilitate access, and to lower the scoring unit to the lowest position. It was pretty easy from

Not sure on the KF but on the k700s that i use to have you have to crawl into the cabinet Regards, Mark https://www.instagram.com/kessler_woodworks/