开云体育

David, My machine label says 50 Hz. I remember speaking to Felder about it and perhaps mentioned it here as well but was told it should be fine. I will check the motor label when I am in shop to see

Reply to existing email messages or to create a new thread, just send it as an email to the group. Brian Lamb blamb11@... www.lambtoolworks.com

Welcome to the group, there is a lot of great information here and I often use the search feature. I have appreciated the help that many members offer here. I had a K500P that I recently sold and have

Given the FD is direct drive, I would think the speed is closer to 3400 in the 60 hz market. Generally you can overspeed a 2 pole motor to about 90 hz assuming the motor is decent quality. Downside is

K Patel, welcome to you as well. Congrats on your new saw. I got lucky and Felder had my saw in stock just sitting in a warehouse, so I jumped on it.

Welcome Steve...am new myself and likewise looking to take ownership of a K700S albeit not until summer. K Patel

After realizing that people have used end mills on their mortising attachment, I was curious if there is a way to increase the RPM of FD250. The bit on morticing attachment is likely running around

Rod i would like to purchase it if available. Thanks. stan

Welcome, I just recently joined as well. Awesome group and congrats on the K700S! -Ameer N.

So I was finally able to get the power drive calibrated, first problem was that the programming code in the attached instructions (2505) was not the correct one for my machine. There are 3 codes

Joe, did you happen to take a picture of the machine with the modified handle control bracket? ?I am interested to see this modification. ?The clamp does get in the way at times. “I modified it in

I have had a Hammer A3-31 for 4 years, a ton of Festool and a new Felder K700S arriving in a week or two. ?So looking forward to getting this saw in the shop.

Mike, I had a chance to take a look at your link and I have to say that is fascinating. I had no idea that That was a shout away from my house. The only thing I knew about was the guy that collected

Welcome! What type of equipment do you have? Bill Bélanger [email protected]> wrote:

I didn't have anyone email me about the Guide, so it's going up on eBay tonight. Take care, Rod

The Hammer A3-41 has the single pole lifting; however, it does have spring assists on both tables, which are co-planar. I had a 12" J/P and sold it last summer, as I often wanted to joint surfaces

Mike, your idea of frames and several people would speed it up further. I just happen to have railroad ties that are 1/4 scale of 2-1/2 scale, and I mocked it up.? A sheet of melamine plywood, a

Welcome…. Brian Lamb blamb11@... www.lambtoolworks.com

New to the group Steve Lyde

Jonathan has the attachment for his CF machine. I'm pretty sure that's much higher RPM than the FD250. Jason Holtz J. Holtz Furniture www.jholtz.com 3307 Snelling Ave. South Minneapolis, MN 55406 612