开云体育

The start/stop buttons are all low voltage that engage or disengage a relay inside the machine to power it on/off. I suspect your relay has burned contacts and is sticking shut. Replace that and it

Hello folks, I’m new here having just purchased a couple of second hand Hammer machines, a B3 Perform and an N4400. Overall I am delighted with both machines, however the B3 has an odd (and very

Have an A3-31 and recently started to develop snipe on the jointer.? It appears the near side (closest to operator) of the outfeed table is not co-planer.? Also, started to develop snipe at the

Thanks for your reply. I'll get back with some pictures. Louis

Hi John: This is excellent news! I’m really looking forward to your impressions as you use the machine, including the really good features and the not so good features. I’m excited for you. Warm

Rod, Thank you for that! Help me understand what is included in “annual maintenance,” and does Felder offer a maintenance manual? I do have an excellent dust collection system, but other than some

Hi Christopher, I've owned one for 17 years without issue and serviced many of the A3 machines.? I've run into that problem twice from people who forget to run dust collection, or forget to do annual

I have a C3-31 and now I’m worried. Any thoughts from all of our experts on why or how this may have happened in the first place? - poor design? - poor manufacturing? - lack of maintenance? Any

Thanks guys, I bit the bullet and took the assembly unit out only to find the threaded rod plastic block (item 7) was blocked with loads of sawdust. When I started the job I noticed this plastic cover

Hi Louis, Please sign your post so we know who we are addressing. I assume you are Louis from your email. I am responding out of courtesy since no one has responded. I think this is likely because you

Hi Jim, I just bend the 4" polyurethane hose with 2 pairs of Lineman's pliers into a rectangular end rather than round. Regards, Rod.

Hi Chris, the feed rollers are located in plastic blocks with a threaded rod, item 7 in the drawing. They can break, or get jammed in the cutter bearing housing item #30. I would start

Any opinions on this?

To follow-up on this thread, Felder did replace the brake board a week ago. So far that has fixed my issue. It was not a voltage problem, or a blade problem, but was a defective electronic

Chris, if this was my machine the level of doubt I would have on using it would always eat away at me. Given that I would suggest checking its seated correctly, and then adjusting from the zero

Whilst I havent levled a CF741 specifically, the location in the chassis for installing leveling feet is usually right next to where the shipping brackets woul have been installed. I've been happy

In the process of calibrating a used A3-31 and stumbled upon an issue with the planer feed roller. The right side is too high and for some reason doesn't rest on the support bolt (see the gap in the

Hi There, I have being looking thorough the manual (User Manual and Schematics) for where the levelling bolts are located on the machine. I am having a challenge to set the beds coplanar and also

Steve, Thanks for being a pioneer here!? I got mine after a bit of a wait.? For something that was made one off from Kundig this was downright cheap. Not sure if you have longer arms than I do

Usually STL is the file format. Brian Lambblamb11@...