开云体育

Anyone have an exploded view of how the bar for the rip fence attaches to the machine? I'm specifically interested in the cast iron top area.

Thank you Imran. I will repost below with part numbers from your diagram. While inspecting the machine, I noticed the angle/tilt wheel is very difficult to turn. From the zero position, it starts

Hi Thomas, I did have a tip on this mechanism in my writeup. See top of page 10. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share Sent: Thursday, August 29, 2024 11:59 AM To:

Hi Thomas, Congrats on the machine. The blade tilt mechanism is silky smooth on my saw. It is easier to tilt as the motor weight is falling and slightly harder to bring it back to 90. Still, I think I

Thanks to generous help from a couple of FOG members, I recently purchased a 2005 K975. While inspecting the machine, I noticed the angle/tilt wheel is very difficult to turn. From the zero position,

Hi Jim, Pics did not come thru…. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Hi, Imran. Here are photos of the electrical panel, autostart box, and control panel. The capacitors are located behind the control panel and seemingly must be accessed from above by removing the

Troubleshooting has a process that starts by eliminating as many factors as possible. Here you are focussed on the capacitor before verifying that the machine is getting voltage, when that is an

Hi, verify that you really do have 240 volts at the machine. Check that the overload relay attached to the run contactor has not tripped (push the little reset button on it with the main switch turned

I talked to a Felder Service Rep today. The capacitors, it seems, can only be accessed by removing the entire top of the RL. A simple access panel would have made more sense to me, but I am not an

Hi Jim, Pictures of the setup, electrical connections will help immensely. Typically 240V will go to the control box. The box then provides the 240 to the RL. It could be something wrong with the box

Breakers to fail martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com instagram.com/maccampshure/ Designing

Imran, the automatic start is a Felder device which is not separately powered. It consists of current detecting rings which detect current flowing to individual tool machines. This signal is

Jim, I'm sorry I can't tell you where the bad capacitor is in your 125. When mine blew in my 160, my son found it and replaced it. I'm pretty sure this is the one he ordered

I took David's question as a suggestion to open up the machine panel bearing the ominous lightening bolt (unplugging first) in hopes of finding a capacitor. In a spaghetti of wiring, found a small

Hi Jim, The 230VAC outlet should measure ~230VAC but since you have automatic start the RL is likely plugged into that unit and that is where you are reading the low voltage. I assume you pulled the

Whether it’s an A3 or my 630 Okoma I size and commonly do that to 10” on edge this is what a sizer is used for to make dimensions S4S. Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave.

Great question, Dave. I am not sure where to find the capacitor or how to diagnose whether it is faulty. I do know capacitors can be dangerous in the hands of the uninformed, like me. Jim James H.

How does the capacitor look? Dave Davies [email protected]> wrote:

My RL125 single phase dust extractor, which has previously worked reliably in both manual and automatic modes, has inexplicably refused to start in either mode.? I have checked the circuit breakers