开云体育

Troubleshooting has a process that starts by eliminating as many factors as possible. Here you are focussed on the capacitor before verifying that the machine is getting voltage, when that is an

Hi, verify that you really do have 240 volts at the machine. Check that the overload relay attached to the run contactor has not tripped (push the little reset button on it with the main switch turned

I talked to a Felder Service Rep today. The capacitors, it seems, can only be accessed by removing the entire top of the RL. A simple access panel would have made more sense to me, but I am not an

Hi Jim, Pictures of the setup, electrical connections will help immensely. Typically 240V will go to the control box. The box then provides the 240 to the RL. It could be something wrong with the box

Breakers to fail martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com instagram.com/maccampshure/ Designing

Imran, the automatic start is a Felder device which is not separately powered. It consists of current detecting rings which detect current flowing to individual tool machines. This signal is

Jim, I'm sorry I can't tell you where the bad capacitor is in your 125. When mine blew in my 160, my son found it and replaced it. I'm pretty sure this is the one he ordered

I took David's question as a suggestion to open up the machine panel bearing the ominous lightening bolt (unplugging first) in hopes of finding a capacitor. In a spaghetti of wiring, found a small

Hi Jim, The 230VAC outlet should measure ~230VAC but since you have automatic start the RL is likely plugged into that unit and that is where you are reading the low voltage. I assume you pulled the

Whether it’s an A3 or my 630 Okoma I size and commonly do that to 10” on edge this is what a sizer is used for to make dimensions S4S. Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave.

Great question, Dave. I am not sure where to find the capacitor or how to diagnose whether it is faulty. I do know capacitors can be dangerous in the hands of the uninformed, like me. Jim James H.

How does the capacitor look? Dave Davies [email protected]> wrote:

My RL125 single phase dust extractor, which has previously worked reliably in both manual and automatic modes, has inexplicably refused to start in either mode.? I have checked the circuit breakers

The same, I was near my planer when I saw the message.

Yes, for the planer. I measured. With it set to plane to an inch. because that is what I was actually doing when I read your original post. Since the planer table descends to accommodate thicker

Great, thank you both! I was thinking it might be a lot lower.

For the planer (thicknesser) not the jointer table?

Posted today, Thanks everyone. https://inlandempire.craigslist.org/tls/d/corona-felder-format4-kappa-400-motion/7778782136.html https://woodweb.com/exchanges/machinery/posts/548091.html PK

Mine lives on a mobile stand. The planer bed is 31" above the floor when set for planing 1" material. I think it is comparable to the shop where I sometimes take lessons where there is both an A3 and

78cm