开云体育

Hi Michael, is there any reason you can’t have your existing groover modified for use on the saw. If you bought a 30mm bore groover just have it bored for the saw pin holes. I have an FS Tools dado

Starrett VERNIER BEVEL PROTRACTOR, WITH 7" & 12" BLADES testequipmentusa.com Accurate and repeatable to an accuracy of 0.08 degrees. David Best

Hi Michael, You did not mention the depth of cut you are after. I recently slapped myself for selling my 200 mm CMT dado after getting my Felder dado set, why because I found out it does not cut very

Gerry- which Starrett product are you referring to? ?If you are referring to a protractor type of gage, then is simply not accurate enough regardless of what has been stated here. ?For the

You also have Ridge carbide that makes a dado set for Felder. The bottom line on the CMT dado was that it is problematic/expensive to bore the pin holes on the spacers/chippers

You can get the Grover bored for the pins if it’s for a 30mm arbor. Several here have had Forrest blades bored.

Hi folks, ??? When I purchased my KF700S, I bought a groover with it.? I *thought* I was getting the one that could be run on the saw arbor.? As it turns out, the one I ordered is only suitable

Jacques, It’s not the way cabinet door mfgs do it but 30 years ago we were doing whole house projects and had trouble with square edge shaker doors cracking at the joint with stub tenons. Especially

Joe, Thanks for sharing. I had never seen joinery combining tenon and dowel in the same axis. I learned something again today thanks to the FOG?. Regards, Jacques

Here are the steps for haunching. It is a bit labor intensive and this doesn’t show cutting the mortise.

Ron, Those are haunched because I wanted a traditional mortise and tenon. I was using the HC mortiser for these and the exposed mortise out on the edge would not be clean. The other option for this

Dixon - DIX00500 Industrial Lumber Crayon Holder for 1/2" Round or Hexagonal Crayons, Wood with Metal Chuck, Walnut, 1-Pack (00500) Walnut amazon.comMine is 50 years old still working perfect. mac,,

Joe is using euro triangle system to show stiles and rails for sash and door, I use a graders marker to rough mark, Japanese knife scribes and .07 H graphite to mark . Mac,, martin/campshure/co/llc

I am using the Pica pencil. You can get the graphite in multiple colors (including white). It is really good for rough dimensions and general marking. It isn’t not good for fine furniture making.

On 16 Jun 2024 18:43, imranindiana <imranindiana@...> wrote: I have been eyeing pica for some time now. I only use pica dry markers in general construction, marking raw dimensions on wood before

Thanks Jacques and Jonathan for your feedback. I have been eyeing pica for some time now. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Very, very nice Joe.? I'm leaning toward something like this for my daughter's kitchen style.? So, the panel is rebated only toward the back so it doesn't a show break from the front, I assume.?

On 16 Jun 2024 15:11, Jacques Gagnon <jacques.gagnon309@...> wrote:A lumber crayon works very well on both rough and planed (surfaced) wood. In my training as furniture maker (EU mainland) I was

Imran, A lumber crayon works very well on both rough and planed (surfaced) wood. As Joe indicated, sanding is required down the road. Since I do not have a belt sander, I use either a Pica red lead or

I have the Starrett version of this - bought it a few years ago on EBay for ~$300 IIRC. It is a little fiddly to set up, but once that’s done it is incredibly accurate. I use it regularly to dial in