开云体育

?Patrick, I cannot really see the details in the pic but if it has pneumatics on each end then it is likely a “beam clamp”, cannot recall the actual name, it’s been several years. I have seen

Woodweb usually has a bunch, but mostly they are 3-phase: https://woodweb.com/cgi-bin/exchanges/machinery.cgi?CATEGORY=Panel+Saws-Sliding&KEYWORD=

I know this isn’t a Felder question, but I’m curious about this accessory and a lot of these guys know Martin kit well too. What is this thing I circled below? Is it just for jointing veneer, or

Jake, You may wish, if you have not already done so, to look at the used equipment portion of the Felder USA e-shop web site. Regards, Jacques

The 30mm version even comes with a metric version of the shim-spacing guide. Such joy. Hallelujah. ? David Best DBestWorkshop@... https://www.flickr.com/photos/davidpbest/collections/

I bought a 30mm CMT Dado set, set it up on a Bridgeport using a close fitting arbour and drilled both holes. The result even though we took as much cares as possible was terrible with the bottom of

If the machine doesn’t have the dado option, which was pretty rare prior to the X-roll, then it’s not going to work. Brian Lamb blamb11@... www.lambtoolworks.com

Does anyone know if this will fit a pre-Xroll KF700?

What are some better sites to look for used Felders?

I would second Bob’s advice about considering a used saw. I don’t want to offend anyone but what I’ve seen is that there are quite a few hobbyist woodworkers who buy after retirement and then 10

American rotary Definitely recommend. I use in my lab 5 hp unit ADX 10 hp generator. martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell

Yes, good point Greg.? Those little 40mm "three hole" knives are mass produced, economy grade knives made from poor quality steel and the grinding is hit or miss.? They are ok, but Whitehill uses

Hi Bram, I have a Hammer B3 with an HC 308 feeder which is similar to the C3. The feeder you provided a link too has a couple of show stoppers in my opinion 1) it uses an electromagnet to clamp it to

Imran, This one is for a 30mm arbor, it is the European version. The sale price in the USA is $120, a terrific deal for this new design dado. James

Looks like sale is universal not as good as $120 though. https://www.scosarg.com/tooling/circular-saw-blades/grooving-saw-blades Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

James, I found this couple of yrs ago at Scott and Seargent when I was selling my CMT dado. My version (run of the mill dado) had been discontinued and replaced with this version. I don’t recall a

Any suggestions on how to get the 30mm arbor and pin holes accurately drilled? Chris Rozycki

Chris I have several Whitehill cutter blocks (and profiles). I get anything that I want from Whitehill faster than I can get an inferior CMT knife locally. (I am in Queensland). ?The Whitehill steel

I just happened to need it so I used the trusty google and found it at “Acme Tools” and if you sign up for texts (you can always unsubscribe later) you get 10 bucks off putting the total at

I got the product email from Taylor Toolswork at 1PM today, but did not check it until now. https://www.youtube.com/watch?v=PGdbK22Y56g&ab_channel=TaylorToolworks Looks like it is a great alternative