开云体育

Thank you James. Looks like a good setup

Wade, It is the router base designed by Scott Grove. You can find lots of videos on youtube. https://www.woodcraft.com/products/ultimate-router-base James

James, Is that a Festool base or an aftermarket? Thx, Wade

JB, If you do a lot of wide solid wood edge banding, Lamello Cantex is the #1 solution. I use OF1400 with Freud 1-1/4" diameter 1/2" shank dish carving router bit on the ultimate router base to trim

Hi Chris , The cutter Brent showed from Whitehall Is a great cutter and there are lots out there . I think it is a good thing to develop relationships with vendors. I am not a good person to ask as I

I have both the Festool MFK setup and the OF1010 w/ an edging plate. I use them quite a bit. I find the MFK works really well for thin edge banding, but not much else. The OF1010 w/ the edging plate

Hi Wade, I usually glue on 1/4" strips and then fit from there. Around 1/8 is ideal for not telegraphing. Jason Holtz J. Holtz Furniture 3307 Snelling Ave. South Minneapolis, MN 55406 612.432.2765

Chris, dedicated cutters are always faster than combination cutters, and large, twin tenon discs are always better than a flush block doing one side at a time....but the cost equation is VERY

Hi Mac, could you recommend a good rebate cutter with steel body/ reversible knife/ side curf cutters etc? Would love a link to what you recommend. Sounds like a dedicated rebate cutter maybe better

J, If this helps in your decision making process, I just installed a 7.5 HP Rotary Phase Converter - GP7PL Single Phase to Three Phase Converter from Phoenix Phase converters. I did the install myself

Hi Jason, Do you recall your edge-bending size for these fronts? Thx, Wade

Thought the discussion was about the CMT Universal cutter martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com

Mac, the cutterblocks we are referring to have skewed carbide inserts with spurs for rabbiting with clean inside corners.? They ALSO can be used to take HSS knives....hence the name "combi". B

I have the OF1010 with the edging plate. I have to say it is awkward to use because of the weight of the router. I think MFK700 is a better choice to trim edge banding. You can modify the 0 degree

Not going to take feed from sheep Pictured non skewed martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com

You can also just buy a 3 phase convertor, it will be significantly cheaper.

These are not a good rebate cutter buy a steel body 125 dia 2 knife reversible with side curf cutters or get side cutters screwed so good for tenon work . These are your basic cutter every one should

I made a cheep set up on my Milwaukee Battery operated 12 v router using offset base. bought a sub base and modified add 3 stand offs and made a guard. This is just to trim plugs . With offset only

I have a rift ash kitchen with MDF core on all the fronts and end panels. It's a dozen years old at least and is holding up well. Jason Holtz J. Holtz Furniture 3307 Snelling Ave. South Minneapolis,

Hi Larry, It's my go to, just make sure you check out the video on festool live on how to set it up correctly. Jim wrote: