开云体育

So to finish this thread, in a conversation with Jeff at Northfield he mentioned that tire concentricity was actually more important than wheel balance. So I made a square sanding block with a

Tim, not sure but I think the mortising units for Hammer and Felder are similar in how they attach and operate. If that is the case, there are no instructions (at least for Hammer), just a one sheet

Marlow I have no truing set up but have an interest my Rapid 640 runs smooth my Oliver 116 36” has a little vibration motor and bearings run smooth at end of shut down , I had a reputable co re

So... getting a mechanically and cosmetically restored Yates Y-30 Snowflake, likely within a month from Ben Rock at Pleasant Street, the same guy one once restored the same model for Sauer and Steiner

Thanks That is golden information there, Bill

Bill, I found my original sketch of the bracket which may be helpful

There is a low voltage power supply that runs the DC motors that take care of rise and fall (and tilt if you have it). Pretty sure there are some fuses involved in the power supply, I would check

Bill, very similar to that - think I just happened to have an off cut available. The leg that holds the sensor was 1.25 and the leg that mounts to the casting was 1.0 inches. 1/8 thick. You'll find

Hi Lloyd I think They offered different configurations, I think basic had one vertical and one horizontal that server as the planer and facer head but not a one pass machine. 3 sided? Mac,,

Mac, Do you have any photos of your truing set up? Marlowe [email protected]> wrote:

John would you mind elaborating on techniques. And Are you talking about the raw wheel or with the rubber Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106

So to finish this thread, in a conversation with Jeff at Northfield he mentioned that tire concentricity was actually more important than wheel balance. So I made a square sanding block with a

Hello group. I have a cf 741 and bought a mortising unit from a private party some time ago. It has been a while since I mounted the unit and wanted to reference some instructions before trying to

Cool,? although it sems aspirational to call it four sided if there are only 2 cutter heads. 16"?125 amp 3 phase service is 125 amps to each leg. Isn't 120 amp 3ph on the nameplate equal to just? 40

Hi all my Felder cf 741s saw rise and fall has stopped working it no longer goes up and down on the adjustment switch or the fine adjustment button but I do have power to the saw if I hit the start

Hi Wade, Congrats on your new machine! Sounds like lead times are shortening… -- Tom Gensmer Heritage Home Renewals, LLC Minneapolis, MN

I put an order in for one as well at the end of December :-) Looking forward to its arrival.

Oh my.. I meant to say fine scotch pad.. 0000 steel wool works just as good too.

I've seen Baurle jointers with the head in the fence. I almost bought one for the jointer but the fence was too incomplete to deal with. Dave ________________________________ Sent: Wednesday, January

Thanks a lot for all the pictures, as I said before, this looks like the simplest solution I have seen so far, and I feel confident I can try to replicate. Your aluminum piece for the sensor/reader