开云体育

I have powerdrive on my first Felder and I insisted on powerdrive for the second machine when shopping used. The tap is not that annoying. I suspect a tap is a perfect increment in metric and when set

Wow that's great. I would buy that in a instant for that price. There are not that many options for resaw feeders and they are so important. I have some homemade pressure wheels and use a power feeder

The Leica unit I have is a Leica Lino Ls-1. Photo attached. Price in Oz was just under A$300. I thought I had a photo of the original set up in my old shop that I sent to my nephew Lucky, but as usual

Thanks – I’m going to give it spin… worse case its $50 on a proof of concept. Regards, Chris Perren 512-415-6951 Sent: Sunday, November 22, 2020 5:05 PM To: [email protected] Subject:

In the ad it says1-2mm wide at 1m, and 2-3mm wide at 3m. So I’m guessing about 2mm, and given your blade is about 3mm, that should be fine enough. Brian Lamb blamb11@... www.lambtoolworks.com

That would work, just not sure how visible these Chinese lasers are if the shop is bright. Somebody will have to give it a try and see. Brian Lamb blamb11@... www.lambtoolworks.com

what Ariel posted, is essentially the package that i have but it is red laser and i paid about half. i believe Jason bought one from the same outfit and his was DOA. the mount has not proven out to be

Thanks Uncle Clint. I thought the cost may be too good to work for my needs. Any photo of your current setup with the Leica unit. I’m assuming the cost is much more for a quality laser. Thanks,

Hi Chris The short answer is...no. I purchased a similar laser to this one first because it was so cheap. It was good enough to establish the principle but not strong and the line thickened quickly.

Will this laser produce a crisp line if mounted from a 10 ft ceiling? A difference of 6 feet from the saw. Thanks, Chris Perren 512-415-6951

No need to do much hacking: 532nm 50mW Green Laser Line Generator Module Locator Marker for Alignment ( https://www.ebay.com/i/133490288766?chn=ps&mkevt=1&mkcid=28 ) It includes power supply and a

How much do you plan on using the shaper and how large of a motor can you get in single phase? At the expense of that machine, I'd want three phase and budget for a balanced rpc or Phase Perfect,

I have a DRO on my spindle moulder (shaper to you guys !) and my thicknesser. I wouldn't be without either. I don't have a power feed on either but if I had the choice I’d put one on the

i would 2nd Mark’s thought on motorized blade elevation without DRO. i have the same setup on K975 and it is tedious if you need to set exact blade height. while cool, i think it should be either

Sure, it may take a week with the holiday, I won't leave you hanging!

As with all things, I guess its how you plan to use it. At our pro shop, we're constantly bouncing back and forth with setups and I know how long manual adjusting and verification takes....and the

Thanks Brett - would you post a picture when you set it up?

Regarding my research and everyone's recommendations, it looks like building and rigging a dedicated laser line with a 90 degree beam is going to be possible and budgeted about $100. But, like Uncle

I too was looking for a laser solution but like Jason i gave up and went back to my trusty gauge block when it matters, when it doesn’t I just eye ball it... Regards, Mark

I have the power drive on the ad941 j/p and the dumbed down version of it on the k700s. On the ad941 i had a little bit of a hard time with the “tap” at first but doesn’t take the long to get