开云体育

Hi Clinton: Do you have any pics of your laser set-up? And what are the laser specs? I often hear the notion of lasers not being strong enough to see in good light, or being too wide to be useful.

I tried to rig up a laser on my Panhans. I bought a relatively high power red laser on ebay, and was intending to mount it to the overarm guard support tube or the dust collection pipe about 7 feet

Well, I spent some time this week with Carl @Felder in Anaheim.? Decided on a configuration I think.? Waiting on a quote.? KF700SP if it is possible to get it in single phase with a 9' slider. I am

Hi guys I made a steel bracket above my slider and mounted a Leica builders laser that has a magnetic base. I placed a two meter straight edge against the blade of the saw and quite easily adjusted

I have to say low angle pocket screws are a revolution the first time you use them.? My brother has a TSM-12 and was preaching to me about it...? So I happened to find a Porter Cable 552 New in the

I have a cut block on my fence so I know we’re the lead edge cut will be and I know where that is on the handle side be just look and feel clamp and cut. If I need to cut to a line I put a light

You can buy old stock open or sealed bearings with little risk unless no longer packed to keep out moisture. If i find an older sealed bearing I need that is difficult to find new, I just pop the

6307. Sealed are fine as the rpm is so slow. You want C2 or CN ( normal ) clearance, not C3. SKF Explorer ABEC 3 or equiv. ABEC is a measure of precision or how concentric the inner and outer races

I haven’t but i think it would be great. [email protected]> wrote:

That's not what I said.

I look for recognized manufacture usually old stock. I wouldn’t consider something on e bay as necessarily junk . All your Felder stuff is sealed bearings.the. Grease is good for at least 10 years

It really depends on what I am doing.? I may go to ebay and get cheap shit or? I may? insist on? Fafner? or Timkin and? then I end up payiing? a lot more.

They are for Tannewitz 30” bandsaw, upper wheel. The size is OD = 80mm, ID = 35mm, width = 21mm Sent: Saturday, November 21, 2020 3:14 PM To: [email protected] Subject: Re: [FOG] Where to

jason, that is a sweet setup. imran

I've alway thought having one would make straight line ripping rough lumber easier. But really hasn't bothered me enough to break down and make one.

What is the application? What size bearing ? Are they for the Tanny wheels? Dave ________________________________ Sent: Saturday, November 21, 2020 3:59 PM To: [email protected]

Personally I would use sealed bearing so you don’t have the mess of grade or oil martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell

What spec bearings do I need, pretty sure the metal shield ones that were in there were not original. I assume I want no seal bearings but what clearance, C3? And what ABEC? Two big bearings support

When retired I will do the same. As someone who works weekdays the commercial places who are only open mon-fri 7-4pm are impossible. Sent: Saturday, November 21, 2020 10:16 AM To:

Cool Jason!, My shop gets up to 35 40 F in winter, little ceramic heater is my friend no sense heating 3600 sq ft for on body martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi