开云体育

Haven't really noticed any wear on the tires.

Okey, 0.001" (0.025 m.m.)? or twice that? sounds more realistic to achieve than 0.005 m.m. In my textbook they recommend using equipment to grind the knives while mounted to get it down to 0.005

Yes martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell 608-824-0023 fax airtightclamps@... airtightclamps.com Designing and building for 47 years

Thanks John, I actually spent a few hours reading many posts about the bandsaws (searched for variations of? "FB" and "610"), but do not remember specific discussion around the proper position on the

Thanks David, it's good to know that someone is using Alex's method for the FB-610 with good results.? Have you seen any issues with the blade chewing up the rubber - having a slight crown should

I have an October 2019 k700s with the 52” rip and the overhead guard, mine drop an ity bity bit if any at all when rotated. Here is how mine is attached Regards, Mark

Good going , figure that system out you deserve a prize!! Moving barrel 6 in and out adjust top and bottom changes the angle of the assembly to move table up and down . I poor design at best. Cutter

Here's the crown on recent vintage FB610, about .015"

Ok, So I blew one of 5x20 1a slow blow fuses. Just ordered some on amazon and they'll be here tomorrow. called felder tech support with the electrician here and they got the wiring all sorted out.

Rough and or wet, i had them on my big SCM and only remember using them at high speed feed rate and just to skip dress Regards, Mark

We just went through this whole topic a few days ago, you will find the answers in previous posts. -- John Kee JMK Servic

You must have different wheels then what I've seen on a lot of Felder bandsaws. All were completely flat. Properly setup with proper tracking and blade tension results in no drift unless the blade is

I follow Snodgrass's method on my 610. I tried the front of the wheel thing and it wouldn't cut straight. Using Alex's method it cuts straight. I find it easier to adjust the tracking than adjust for

Think those are the correct ones but you could always give Felder a quick call and confirm that they are the correct ones.

The only time I thought bed rollers were worth the effort was when they were powered. Few are now so I'd save the 750 unless you run really rough stock. Dave ________________________________ Sent:

Frost King V23WA Ribbed Rubber Self-Stick Weatherseal Tape, 3/8" W, 1/8" T, 17 ft L, White https://www.amazon.com/dp/B000OZT84K/ref=cm_sw_r_cp_apa_i_ougtEbJ87DGHB This works great for 5 and 6 inch

Integrated adjustable rollers for AD 951 is a feature offered for the Felder 951. Anyone have experience with using this machine with and without this feature? It's an upcharge of $750. I have always

Definitely not as easy to reconfigure the spiral compared to clamp together especially if you need to change something in the middle of a run, not sure if it’s worth 4-5 times the cost of spiral

I own a Felder FB 510 and have run my tyres centrally - without realising the profile is close to flat rather than crowned as some posters have pointed out. But I have experienced no issues. My

I really like the Nordfab ducts.? I reconfigure it for new machines and took less than an hour.? I don't think you can do it as easily with spiral ducts when I was researching the two options.?