?

Hi Mac,?

the attached photo shows the infeed table height adjustment. (just learning, do attachments work in this forum?)?

The table is in the flipped up position. Bottom left corner is the octagonal table rest. Have adjusted that, it helped a bit.?

Black plastic covers in the lower center expose four bolt heads total, which thread straight into the inclined lift/lower mechanism. Is it tuning these bolts that you are suggesting??

Also, notice the four bolts on the underside of the table? I could open and adjust these, but doesn't look like it would move it. The shape of the mating faces dictates that each of them would just center itself when tight (I think). Here's a closeup of that:

Any further thoughts in this would be very much appreciated. (or does anyone have any instructions from Felder?)?

Thanks,

Neil

On Dec 7, 2017, at 7:49 AM, Neil Carrodus <neil.carrodus@...> wrote:

Thanks Mac, Here is a picture if it helps to refresh your memory:

This is at the outfeed end, but infeed is pretty much the same, just mirrored.?

Thanks,

Neil

On Dec 7, 2017, at 6:32 AM, mac campshure mac512002@... [felder-woodworking] <felder-woodworking@...> wrote:

?

Neil,?

Done this more than a few times.

The question is do I remember.

The table runs on 4 inclined ways. There is a squeeze bolt needs to be loosened.

Know I forget how the assembly is raised I will have to look at a drawing and get back with you,?

Pretty sure it will be obvious. ?

Just do little at a time there is an octagon bar on the operators side that also my needs to be adjusted the assembly base to meet perfect or when you tighten it it will throw your adjustment out this is adjusted with jack screws over and under the chassis.?

Mac,,

martin/campshure/co/llc
mac campshure
7412 elmwood ave.
middleton, wi 53562-3106
608-332-2330?cell

608-824-0023?fax

airtightclamps@...

Designing and building for 47 years

Neil ?Carrodus

604-753-9458

On Dec 7, 2017, at 12:05 AM, neil.carrodus@... [felder-woodworking] <felder-woodworking@...> wrote:

?

Hi, brand new on the forum here, excuse me if I'm not using it properly.

Looking for a bit of help as my manual seems to be mostly silent on the issue of making adjustments to the jointer tables. My infeed table seems to not be parallel with my outfeed (not co-planar). A straightedge flat on the outfeed reveals an 1/8 gap at the far end of the infeed (and vice versa). I'm getting concave boards!

Anyone have experience solving this on the BF 6-31? I assume it is some adjustments to the hinge and latch mechanisms, but not wanting to monkey with it till I know I'm not throwing anything else out of whack.

Any help would be greatly appreciated.

Neil