I just posted a file describing a new device which controls a dust collector and blast gate when machine is turned on/off. ?
This past spring I purchased a Felder KF700S sliding table
saw and shaper combo. ?I also installed
Nordfab ducting to the machine which included an automatic blast gate at
ceiling height.? My dust collector is an
Oneida Smart Pro 5HP unit with an RF remote.?
In my small one person shop, the dust collector does not run
continuously ¨C only when machines are producing chips.
?
I wanted the dust collector to turn on automatically
whenever I turned on the saw.? The blast
gate must open at the same time.? When I
turned the saw off, the collector would run for a programmable number of
seconds before turning off and then closing the blast gate.? I wanted the dust collector to turn on via RF
as I did not want to run wiring or disable my current RF remotes.
Check out the unit in operation at??
Dan Schmidt
