Paul,?? I had a similar
problem once and it needed a slight adjustment of the outfeed rollers. Also had
the problem when I planed down some pine or spruce that had a high moisture
content.? If John H can't get back to you today give me a call and I'll see
if we can't solve the problem while we're both at our machines.
Take care,
John Renzetti
toggle quoted message
Show quoted text
----- Original Message -----
Sent: Friday, March 17, 2000 11:23
PM
Subject: [felder-woodworking] Outfeed
roller
I have had a little problem with the planer in that when thickness
planing a 6-7 inch wide board it runs smoothly until the last 4-5 inches and
then hesitates or stops until I assist it by pulling it out. I spoke to John
Hartshorne today and he recommended cleaning the table very well which I did
and then to try lowering the outfeed roller a little at a time.? I did
this to the point where the shaft of the roller is almost touching the housing
so I"m not sure I can lower it much more. It has helped but not solved the
problem. I am still in the process of adjusting. Has anyone else had a similar
problem and a solution. I will call John back next week but alas the weekend
is here.
To Post a message, send it to:?? felder-woodworking@...
To Unsubscribe, send a blank message to: felder-woodworking-unsubscribe@...
eGroups.com Home:
- Simplifying group
communications
