Hi Darrell,
I¡¯m trying to understand how the far end of the indeed table affects the cut?
If your cut is bad I think I¡¯d look elsewhere?
Bill Belanger
toggle quoted message
Show quoted text
On May 27, 2025, at 17:45, DARRELL MILLER via groups.io <dmiller823a@...> wrote:
Hi FOG members!
I purchased and setup a new AD941 (jointer/planer) combo back in early 2024. ?I used the Survival guide and other materials from David Best and his guidance to accomplish this and I was quite satisfied with the results. However, twice since then I've found the infeed table has come out of alignment. Both times the end of the infeed table (furtherest from the cutter block) has drooped down by ~ 0.032". This seems to happen overnight, since the day prior it produce good results. Have any other owners of the AD941 experienced this phenomenon? If so do you know what would be causing this? Any suggestions on where to look for the issue would be helpful.
?
Best regards,
Darrell Miller
Chico, Tx
Bill Belanger