¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io

Re: Shaper hose replacment KF 700


 

Thanks Imran. My power feeder too is resting .? My 2008 machine also rests on the F rail, but has an. 80 mm hose which is? longer, as it goes down to the bottom edge of the cabinet.
Based on your experience, I'll try to spin the power feeder over to the saw deck, unweight it by lowering to the table, and maybe lift the inner part of the? tube so that when I undo the mounting bolts I can pull it out far enough to free the plastic shroud. Then hopefully can get at the upper hose connection.? And see if I can persuade my 3D printing friends to make me two 80 mm to 2.5" adapters. Mike

Join [email protected] to automatically receive all group messages.