On Apr 12, 2025, at 16:17, Aaron Inami via groups.io <ainami@...> wrote:

?

I made my own FAT/MFT table by laminating two layers of 3/4" maple plywood and then a 3/4" solid maple piece for the border.? Drilled out all the hole using a cheap Bora Centipede MFT table as a pattern and a magnetic drill to ensure the holes were perfectly vertical.? A couple of 20mm Fisch forstner bits.? The table came out pretty damn flat when checking with a 6 foot Stabila level.??

?

If I had to do it again, I might just get a 1-3/4" Boos Block piece:

?

-Aaron Inami