Re: Shaper Spindle Question
|
We¡¯re We¡¯re talking about sliding tables that are mounted to the side of the machine and could up or down or parallel for that matter Designing and building for 50 years
toggle quoted message
Show quoted text
On Oct 8, 2024, at 11:08?AM, Brian Lamb via groups.io <blamb11@...> wrote:
? By definition, any sliding table going past a vertical spindle will give you a straight cut, so as long as your piece is set up square/parallel your results will be correct. This has more to do with the fences on the sliding table, not the actual sliding of the table.
Brian Lamb blamb11@... lambtoolworks.com
On Tuesday, October 8, 2024 at 06:14:45 AM MST, mac campshure via groups.io <mac512002@...> wrote:
Albert interesting I was curious does the machine also calibrate the sliding table to run parallel with the cutters on the spindle? Designing and building for 50 years On Oct 8, 2024, at 12:44?AM, Albert Lee via groups.io <timbershelf@...> wrote:
? I like reading comments on questions like this, so I can learn a thing or two....
?
Fortunately with my spindle moulder TI145EP there is auto calibrate function to a built in "true perpendicular" and relative fence positions.?
?
I discovered this function while investigating why the tenon plate is cutting trapzoid rather than square - turn out the spindle was out by 0.9 deg.?
?
by pressing auto calibrate the spindle will perform series of movement and then tells you certain parameter is out.?
?
If the true perpendicular is out of whack it can be adjusted manually.?
|
