Hi All,
I have been through the threads on K700 start up issues and haven't been able to resolve mine. I haven't spoken to Felder yet as its a long weekend. Here are the symptoms and my steps to remedy:
1. Saw started to have intermittent starts - jiggled the saw blade door to cycle the safety switch - rotated the main power switch and saw would start again.
2. This would happen at random times, cleaned the safety switch - still happening.
3. Finally went dead - no start at all.
I swapped out the start and run caps for new on hand, they come back in good state at test, but I may have goofed their wiring positions - see below pic
I took the blade guard door wiring out and jumped the slots to see if I could bypass the safety switch to test... will this work? - see pic below
I get proper voltage from the wall to the main power switch, but I don't here any magnetic clicks when saw is plugged in or power toggle flipped....
Both fuses test as working.
The saw is single phase, 2008 K700 with a 3Kw motor.
Any help would be greatly appreciated, specifically if I should be hearing any magnetic pops when power is activated??
Much Appreciated,
Alex
Bespoke Woodworking
