I built a router table setup that is used in place of the out-feed table on my K700S slider:
I've documented the entire process in this thread below, but let me know if you want me to answer any specific questions here.?
The two things you need to watch out for:
1. space for the outrigger support.? I had to build a custom notch to allow for that support bar to angle in/out (you can see in picture).
2. The table top must extend out from the frame to allow room for stuff like the overhead support system.? You may end up re-doing the table/frame assembly if you find stuff in the way.
-Aaron
