¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io
  1. Felderownersgroup
  2. Messages
Single Messages Topics Expanded Polls

Re: Shaper comparison

 

In addition to the fine advice offered, I will add that you would be better off with a 1 1/4" spindle.? This is the standard for most good tooling.? If you expect to get some 30mm cutters in the future you can add a 30mm later, or add a 1" and use bushings to get to 30mm.

Marlowe McGraw

On Wed, May 1, 2024 at 9:41?PM Albert Lee via <timbershelf=[email protected]> wrote:
I have not attended Alpine woodworking class but I have heard it is very informative, if I was in the states I would definitely signed up..?

Before I bought my SCM shaper with side tenoning table I was a little hesitant. Joe chimed in and cleared my doubt - Thank you Joe.?

I have a Comatic DC40 on my shaper. a definite must.?

the timing to buy a machine is critical. I bought my ti145ep at the height of Covid. SCM gave me a huge discount.?

Join [email protected] to automatically receive all group messages.