Re: Replacement of internal dust hose is K3 Hammer slider
¿ªÔÆÌåÓýFWIW, here are the details of the KF700 rectangle to round transition. First it is a 2 pc design with a point and a groove. The pieces came apart as I removed it. I guess the adhesive finally gave up.V groove Mating point Inside dimension of the rectangular opening is 36x124mm and the outside dia of the round end is 100mm. The transition sweeps 20-30 deg towards the rear of the machine and ~30 deg downwards. Following pics attempt to show this. Sweep downward: Sweep towards rear: Imran Malik On Mar 28, 2024, at 1:29?PM, Jim Fleming <jameshfleming@...> wrote:
? Infer, I like the looks of the printable adapter.? However, I am concerned about conflict with the lower blade pulley.? The picture of the guts of a C3 machine shows the pulley above the bottom of the port/chute.? My measurements show the pulley on the K3 machine extending about 3/4" below the bottom of the port/chute.? Since the adapter bends back under the trunnion assembly (a good idea for clearance from the cabinet side), it might put the exhaust hose too close to the blade pulley.? I have messaged the author of the adapter about that issue.? PS My measurements could easily be wrong.
|
imran