FYI
My inserts are quite large .
On my SCMI ?SI 16 TW my whole saw assembly moves 5¡± to left of slider quite handy win ripping away from slider or pre cutting part before end profiling on shaper.
Included is a 6 position turret for common positions.
mac,,,
Designing and building for 50 years
toggle quoted message
Show quoted text
On Feb 11, 2024, at 7:29?AM, imranindiana <imranindiana@...> wrote:
?
Hi Steve,
I assume you are asking for the 45 deg as the blade can be raised for 90 deg kerf. I was cutting a scarf joint on 9¡¯ long walnut boards that were 1¡¯ wide. One piece had to be cut upside down and I was concerned with tearout. I just cut it and it turned out fine.??So I probably won¡¯t not dealt with it until I need it next time.
I assume this is easy when making on CNC unless one is looking for the exact kerf width for zero clearance.
I don¡¯t really need zero clearance, just don¡¯t like small slivers falling below table.
On Feb 11, 2024, at 7:55?AM, Steven B <sb@...> wrote:
?Imran, how did you make the cut for the scoring blade?
Steve
