开云体育

Thanks Jonathan and David,

I’ve had JoinerCAD for a few months, I’m pretty familiar with it.  It definitely speeds up carcass and shelf creation, but it still requires the drudgery of importing STP files for each different connector.  It also still requires you to physically place the connectors on the model rather than adapt to add the correct hardware spacing (or even type)

Ok, I had the impression that if you spend a little work you could automate this fairly easily, per the link posted in the previous mail, see below:

On Jan 31, 2024, at 1:41 PM, Jonathan Martens <jonathan@...> wrote:

Here is their Youtube channel with more show cases: , there is even a video on explaining how to create a autmated way of placing rafix S20 connectors: 

They have a few (very limited set) of them prepared already judging from the video and the link in the comment section:

Kind regards,

Jonathan