Re: stuck blade, not bad switch
¿ªÔÆÌåÓýWow, it appears that the brake was engaged/operating.Did you by any chance start the saw and stop it and then restarted while the brake was still operating? If not then, it is possible that the brake is coming on when it should not. Imran Malik On Jan 2, 2024, at 10:58 AM, Bob Wise <bob@...> wrote:
? I've had this intermittent problem on my 2006 K700S? which I posted on here before where the saw won't turn on. Got some appreciated?advice about troubleshooting the switch. Wasn't able to find the problem. Note that I habitually?use ear protection.?
Yesterday I turned the saw on for a small cut and skipped the ears. Blade didn't spin up but I heard a low hum when I hit the on switch. Turned it off. Pushed the blade with a push stick.... it was hard to turn, but then it loosened. Hit the on switch, started up and ran great. Has happened again once since that first time. Any?suggestions for troubleshooting? Problem with the brake not disengaging maybe? -Bob |
imran