Re: Failed engine brake 220v single phase C3-31
¿ªÔÆÌåÓýI have a 2016 model C3 31 and had a faulty brake board which I replaced myself
I was quoted replacement cost of just the brake board and as the cables are all terminated with plugs I was able to swap it out myself to resolve the issue
I don¡¯t know what was faulty with my original board, it was most likely the ceramic fuse according to Felder but mine was fine. I¡¯ll post some pics of what the board looked like to see if you have a similar looking board in your model
Cheers
Nathan
From: [email protected] <[email protected]> on behalf of imranindiana <imranindiana@...>
Sent: Wednesday, July 26, 2023 10:14:41 AM To: [email protected] <[email protected]> Subject: Re: [FOG] Failed engine brake 220v single phase C3-31 ?
Hi Brian,
Did they say why the entire electronics need changing or what that actually means? Entire brake circuit or the whole machine?
I have seen some pics of Hammer brake boards trying to help other. The pics were not from top so I may be missing something however I did not see a programmable device. This is good news because if true the board can be repaired. There was also a fuse
to these 2 boards so that can be checked as well.
How long has it not been working. If you want to explore fixing it, contact me privately by clicking on ¡°reply to sender¡± at the bottom of the email.
Imran Malik
On Jul 25, 2023, at 6:18 PM, ibsenafshar <brian@...> wrote: ?I know this has been discussed recently but despite searching I was unable to find a solution, so here I ask. A 23 year old C3-31 in which the blade takes 25 seconds to stop, with power to the machine and without- no difference. Felder says
I will need to replace the entire electronics at $500 to $800, Yikes. I can see the brake on the wiring diagram and in the machine, (3) ~#10awg black wires and (2) smaller red wires. Can anyone point me at a possible solution, or source of a replacement braking
device?
Thanks to all, Brian(J) |
Nathan D'Elboux
