Thanks for the input Alex.
On Fri, 30 Jun 2023 at 17:57, Alex Bowlds
<aabj@...> wrote:
Hi Simon,
I can¡¯t tell how far off the part is from ¡°flat¡± from the photo. ?But it looks like there may be enough material to machine the part so that it is flat. ?This might be an option if a replacement is not available. ?I am also wondering if part of the problem might be how it is attached to the base. ?Was it originally too wide where it is bolted to the base, and squeezed into place, causing the bend. ?It looks like a piece of cast steel or cast iron. ?They are prone to breakage if they are stressed too much, but they will bend, to a point.
Good luck,
Alex
On Jun 30, 2023, at 4:00 AM, smo_motion via groups.io <smo_motion@...> wrote:
Hi there,
We have noticed that our casting on this 2007 cf741s rip fence is massively out of square. Is this by design??
Thanks
Simon
<20230630_115557.jpg>
Simon Ballard