My bad¡my machine does ?buzz but most noticeable after the Planer/thick esser had spun down¡.which it does well wthin the 10 seconds. ?The table saw also breaks but, having higher inertia, pretty much takes up the ten seconds and the noise from the blade spinning masks the buzz.
HTH
toggle quoted message
Show quoted text
Thanks for you replies so far.
I have gone back to have another look and I¡¯d be keen to understand on average how long it takes others jointer helical heads or spindle router spindles to slow, the break might not be applied on my saw at all, that would make more sense than
two out of the three motors doing it and just not the saw because all other switching functionality works fine otherwise
I may reach out to Felder also for a question, looking for an exploded schematic of the C3 31. If anyone has one would you mind passing it on if it¡¯s pdf format
Thanks
Nathan
Nathan, my CF 741 saw has the buzzing sound. It used to stop quite quickly, but it now buzzes for a long time before stopping. I need to look into what¡¯s going on I suspect it will require some adjustment. I¡¯m hoping something relevant comes up in this
post.
Murray
