Calibration of Format 4 Kappa 400 x-motion saw
|
Success! Thanks all. Emery?
Begin forwarded message:
toggle quoted message
Show quoted text
From: Emery Salesky <emerys22@...> Date: February 26, 2023 at 9:52:08 AM EST To: [email protected]Subject: Re: [FOG] Calibration of Format 4 Kappa 400 x-motion saw
?
I loosened nut #7 instead of #3 not realizing that the bolt geometry and tolerance didn't allow for lateral movement.? I did so in the misguided belief that I wouldn't have to adjust the height nuts, #3, yet again.? I will try again, this time meticulously following your video's David; and yes, I did watch all of them.
I will also check for "paint lock" Mac.
The toe-out measurement was done in strict accordance with your video David.
Thanks all again for all of your help.
Emery
On Saturday, February 25, 2023 at 10:18:24?PM EST, David P. Best <dbestworkshop@...> wrote:
Excellent point Mac. ?I found a couple of the studs on my Kappa 400 to have the spherical washers imbedded in the paint. ?
David Best
DBestWorkshop@...
https://www.flickr.com/photos/davidpbest/collections/
https://www.youtube.com/@David_Best
On Feb 25, 2023, at 6:32 PM, mac campshure via groups.io <mac512002@...> wrote:
The bottom cylindrical washer is probably stuck to paint or power er coat knock with a block, I normally grease between the concave convex washers .?
|
