Sorry John Just saw your replies. Not sure about the splitter yet, it seems ok but I have not checked it with anything as I have bigger problems.?
Thanks for all the help/suggestions. Got a few hours over the passed few nights mess with it a little. I squared up my fence to the front of the table and indicated off of that. At 90 was 3 thou wider at the back. At 45 it was off a lot more than that and was tighter at the back. I moved the fence to recheck it tonight after moving the trunnion a bit and found what I think is a bigger problem. The dovetail on the front of the saw top is a heavy 1/16" in front of the jointer planer dovetail. In the picture below the jointer is on the towards the bottom and saw table towards the top. I have not fully checked the jointer calibration yet other than jointing some boards and everything came out straight and square. The previous owner said he had not touched the outfeed of the jointer and judging by the paint/bolts that appears true. It looks like I have a little clearance room between the cutterhead and jointer bed to move it forward but was really hoping not to mess with that. Anyone dealt with this/have suggestions? I drove from NY to PA with this, about 4hrs, I imagine something moved just not sure where to start the check.
Thanks in advance for any help at all,
Adam
