Mark, before I got my 3 phase completed I had to do a lot of this kind of thing on a router table. It was all hand fed, and while tedious the results were fine. I used exclusively soft woods and mdf, so can¡¯t comment on the oak. I have run a lot of red oak through my shaper though and it didn¡¯t seem sensitive to feed rates etc.
36 shutters 26 x 54, 25 six panel doors, acres of frame and panel detail¡
I used bits from Infinity with only the very occasional touch up with a diamond file.?
That said, I hope to never use my router table again now that I have a proper shaper. Well, three in fact.
Greg
?
