Yes, you can use a flat bar. You will need multiple tapped holes if you want to fix it in place.
toggle quoted message
Show quoted text
Brian,
So there¡¯s no need to have a traditional shaped t-nut. ?Flat bar works fine? ?Is that even if you want to fix the nut in place? ?
Thx,
Wade?
On Feb 16, 2022, at 11:57 AM, Brian Lamb <blamb11@...> wrote:
?
I use 1/2¡± x 1 1/4¡± flat bar stock and then drill and tap whatever thread you want in the middle.
I wonder if I missed getting necessary accessories, like clamps and a ripping shoe, when I ordered my saw. I¡¯ll chalk that up to not knowing much about the saw when I bought it.
I see that the Felder store is out of tee-nuts for the slider groove. They want $35, but it is not clear whether that is one nut or a handful. Any other sources for this sort of thing?
What are the dimensions of the tee-nuts? There is a wide variety of tee-nuts available through Grainger and Other industrial supply places, or I could have someone make a few for me, but I would have to know what dimensions to look for.
Thanks for any guidance!
--
John Hinman
Boise ID
Not a Felder Owner yet - expecting K700S in February and A941 in April 2022
