On Feb 12, 2022, at 4:15 PM, imranindiana <imranindiana@...> wrote:

Thanks David. I see they have one 18” long. Not sure if that is the short or long side but will get one. If nothing else, good for layout.

Imran

On Feb 12, 2022, at 6:08 PM, david@... via <david@...> wrote:

?

Imran, ?Here’s another alternative - it’s what I use for checking miters and 45° crosscut fence position. ?Not the most durable thing in the world, but it’s not expensive either.

David Best

On Feb 12, 2022, at 2:14 PM, imranindiana <imranindiana@...> wrote:

I have what you shared and that is what I used however it’s long side is 6” and I had that along the xcut fence. So 4” along the blade. I have Brian’s too but it does not have a 45. So was looking for something with ~10-12” for the short side so I get good coverage if the blade plate.

Imran

On Feb 12, 2022, at 5:04 PM, david@... via <david@...> wrote:

?Imran, you might consider something like this:

Or get Brian’s square.

Then use a dial indicator against the leg like this

David Best

On Feb 12, 2022, at 1:49 PM, imranindiana <imranindiana@...> wrote:

Thanks Jason. Unfortunately, I do not have the indexing feature on my K975. Just the miter scale on middle extrusion of the outrigger.

Imran

On Feb 12, 2022, at 4:34 PM, Jason Holtz <jholtzy@...> wrote:

?

I routinely use the 45° pin stop for the long crosscut fence on the KF700. I always do this with the fence in the front position, closest to the operator side. I always prefer this for cutting solid wood. I ensure the blade is square to the slider then cut all my miters at that setting, not bothering to go 45° the other direction. As mentioned before, cut the Hoffman keyways glue and your done. It's plenty accurate for frames up to 5' x 7' in my experience.

Jason Holtz
J. Holtz Furniture
3307 Snelling Ave. South
Minneapolis, MN 55406
612.432.2765

--
Jason
J. Holtz Furniture
3307 Snelling Ave. South
Minneapolis, MN 55406