David, your a smart guy!
Video attached. ?It just went over .010 in one spot! ?
I¡¯ll forward this to Felder as well
toggle quoted message
Show quoted text
On Feb 12, 2022, at 9:34 AM, david@... via groups.io <david@...> wrote:
?
Rotate the rip fence housing around and upside down. ?Mount the dial indicator mag base somewhere inside the rip fence housing and indicate over and down to the wheel. ?Then carefully rotate the wheel and observe the indicator reading. ? If the indicator reading changes more than say 0.010¡± as it¡¯s rotated, then the wheel is defective and causing your fence to bounce up/down as it traverses the surface of the machine. ??
David Best
https://www.instagram.com/davidpbest/
Yes,
Just bought one prior to the saw showing up. ?
Thx,
Wade
On Feb 12, 2022, at 9:13 AM, david@... via <david@...> wrote:
?
Are the two nuts, circled in red, only to adjust the rip fence 90 degrees to the table surface? ?And the ONLY way you want to dial in your toe out is through the adjustments of the large 50mm support bar as you described David?
Correct.
Do you have a dial indicator with magnetic base? ??Similar to this?
David Best
<magneticbasedialindicator.jpg>
