I had this bumpy issue too on the k700, i was able to get it pretty close after spending a lot of time. The k940 suffers this issue much less, the sheet steel table is beefier les twist in it and it has fine adjustment as it connects to the cast different, it not just bolted. The k700 is fine but the k940 is a pretty big bump in small details like this all over.
toggle quoted message
Show quoted text
On Feb 11, 2022, at 10:43 AM, Jason Holtz <jholtzy@...> wrote:
?
If you're using the rip fence for much other than a bump stop in tandem with the crosscut fence you're not using your slider right!
Jason Holtz
J. Holtz Furniture
3307 Snelling Ave. South
Minneapolis, MN 55406
612 432-2765
--
Jason
J. Holtz Furniture
3307 Snelling Ave. South
Minneapolis, MN 55406
