Looks like the bar is too far out, maybe it¡¯s flexing and causing some of the run issues. I thought there was a spec in the paper work that came with the saw but a quick call/ticket to Felder might be useful?
toggle quoted message
Show quoted text
On Feb 10, 2022, at 11:17 AM, Wade Dees <wjdsignature@...> wrote:
?
Sorry about that. Meant to attach these pics too. ?And good thought Mark, I¡¯ll send a video.?
On Feb 10, 2022, at 7:36 AM, Brian Lamb <blamb11@...> wrote:
?
Pictures? Hard to make any comments based on your description.
Hey FOG¡
I¡¯m not sure if I¡¯m the only one thinking this, but did Felder cheap out on the rip fence for my K 700 S? ?I¡¯m a bit disappointed in the some?of action in the rip fence. ?When I want to bring the fence over from the far side of the table (1200mm rip capacity) closer to the blade, and I want to move it in a fairly quick fashion, the fence wants to bounce a bit as it¡¯s being moved across the table. ?A bit annoying. ?Is the support wheel out of round? ?Just not sure. ?Then when installing the rip fence support bar, the mounting threads to the table extension are just barely long enough to?make the assembly. ?And now I was just making the calibration for the scale on the rip fence and I¡¯m getting accurate measurements off the scale at 0-20¡± then after that, as I get further away from the blade the scale is getting off. ?Is there a bend in the support bar that might be kicking the fence further away from the blade? ?Any thoughts?
Thx,
Wade
