Thank you Bill,
With a 50.20mm length showing, there must just be a very small part trimmed off the end after passing by the blade. ?Would you recommend a backer behind the ZCI when I first cut through this material or does it trim really clean?
Thx,
Wade
toggle quoted message
Show quoted text
On Jan 28, 2022, at 12:38 PM, Bill Belanger <Bill@...> wrote:
?
Yes Wade,
You can find them here;
I have both blue and black ones.
Not a fan of the Etsy thing, but it made transactions simpler for everyone.
Bill
Hi Bill,
Are you still selling zero clearance inserts for the end of the large Format cross cut fence?
Thx,
Wade
On Jan 28, 2022, at 9:19 AM, Bill Belanger <Bill@...> wrote:
?
Bob,
The bed on my printer is only 250 mm.
Bill Belanger
On Fri, Jan 28, 2022 at 08:48 Bob Wise <
bob@...> wrote:
Am curious if 3d printing a zci is viable out of either ABS or nylon. Thinking PLA might be too brittle.
On Thu, Jan 27, 2022 at 6:56 AM Mike <
mike@...> wrote:
Thanks, everyone, for your helpful comments. My wish list was created to save time. Now, I realize it would take more time (and money) to source most of them than to make them or make due.
- I will fill the gaps on my heat-shrunk 4" elbow for the overhead guard and ignore it.
- Last night I "machined" slider inserts with a hand plane using a scrap of 150-yr-old oak (very hard and stable).
- I'll continue using hose for the shaper duct, similar to Bill's picture.?
This leaves the zero-clearance throat plate. I'm tired of pulling slivers of wood out of the ducts when they get sucked in, and I don't want to dedicate the time to making the throat plate. I wonder if something other than the $82 Felder () is available. Since John Renzetti's email was omitted and I have a KF700S (not a K940), I'm still looking.
Thanks again,
Mike
