开云体育

Hi Bill,

Are you still selling zero clearance inserts for the end of the large Format cross cut fence?

Thx,

Wade

On Jan 28, 2022, at 9:19 AM, Bill Belanger <Bill@...> wrote:

?

Bob,

The bed on my printer is only 250 mm.

Bill Belanger

On Fri, Jan 28, 2022 at 08:48 Bob Wise <bob@...> wrote:

Am curious if 3d printing a zci is viable out of either ABS or nylon. Thinking PLA might be too brittle.

On Thu, Jan 27, 2022 at 6:56 AM Mike <mike@...> wrote:

Thanks, everyone, for your helpful comments. My wish list was created to save time. Now, I realize it would take more time (and money) to source most of them than to make them or make due.

- I will fill the gaps on my heat-shrunk 4" elbow for the overhead guard and ignore it.
- Last night I "machined" slider inserts with a hand plane using a scrap of 150-yr-old oak (very hard and stable).
- I'll continue using hose for the shaper duct, similar to Bill's picture.?

This leaves the zero-clearance throat plate. I'm tired of pulling slivers of wood out of the ducts when they get sucked in, and I don't want to dedicate the time to making the throat plate. I wonder if something other than the $82 Felder () is available. Since John Renzetti's email was omitted and I have a KF700S (not a K940), I'm still looking.

Thanks again,
Mike