Re: Newest Splinter tongue design for non-DRO fences
|
Correction: The thread and screw are 1/4 x 20 not 1/4 x 18
On Sat, Jan 22, 2022 at 4:08 PM Fred Rossi < fred@...> wrote: Super simple. I cut a long piece of oak to mate the printed block, cut a few lengths to match the block width (1/8¡± round over bit for the inside match), double stick tape block and wood together, drilled the whole thing twice with a 13/64 bit, tapped the block with 1/4x18 tap, enlarged the wood holes and used 2 1/4x18 1 3/8¡± long screws to hold it all together.?
The wood was made about 1/4¡± too wide so I could run the whole assembly past the saw to create a zero clearance. I am going to make another ?for a 45deg cut zero clearance.?
Hope?this helps.?
Fred?
On Sat, Jan 22, 2022 at 3:35 PM G. Lane < lane247@...> wrote: Hi Fred..? i love that design change!!!..may i ask? how the sacrfical block is attached to the plastic??? I may modify? mine? to your arrangement when i wear it out
_____________________
Fred Rossi 617.905.6497
-- _____________________
Fred Rossi 617.905.6497
|
Fred Rossi