The DRO version on the left fits my Kappa 400 and one other person¡¯s so far. The Non DRO on right I have not been able to get any feedback on.
On Tue, Jan 11, 2022 at 12:30 Brian Lamb <
blamb11@...> wrote:
Here is a picture of the two different fence extrusions (well, the current X-roll, DRO and Non-DRO). The Larger DRO unit fence is on the left, the smaller, non-DRO is on the right. Two different animals¡.
On Jan 11, 2022, at 12:19 PM, Brian Lamb <
blamb11@...> wrote:
Correct, for the NON-DRO model, I didn¡¯t do a design for the large DRO fences with the split stud mounting. If folks figure out the distances, I¡¯ll re-design both with enough meat on the end to be trimmed.?
On Jan 11, 2022, at 12:11 PM, Bill Belanger <
Bill@...> wrote:
Brian,
What you see with the holes is the one you labeled the newest.
Bill
Thats doesn¡¯t look like the proper fence extrusion for the non DRO stop, I think that¡¯s the DRO version. Try printing the other model.
Hi. Here are some pictures of my situation. It did need to be a little longer as per pics and I had to trim the width of the tongue where it fits in extrusion. I gave a kappa 400. Trimming width was easy and then I just threaded a 5/16 bolt in to expand the flanges and hold it tight. The only change that is harder to adjust for is the overall length to reach saw blade.? I need another 5/16 inch. Extra long is easy to deal with.?
Elwin
<image.jpg><image.jpg><image.jpg><image.jpg><image.jpg>
On Jan 11, 2022, at 09:55, Bill Belanger <Bill@...> wrote:
Right, so it looks like I will need a measurement from the saw owner before I print anymore. I thought these should be standard.
Hold the presses! ?
Bill Belanger?
On Tue, Jan 11, 2022 at 09:45 Brian Lamb <
blamb11@...> wrote:
No problem, there are so many variations in this stuff though, creates a major pain in the butt.
Sorry Brian, just trying to make a suggestion that might work for everyone.
?I have zero interest in a 3d printed splinter tongue so I should have stayed out of it, my apologies?
Bill Belanger