Michael,
It was not stock. ?I sent in measurements and they made the spindle caps.
Since they made them once they probably have the design. ?
My first ?spindle cap had a thin top cap and broke, the other three spindle caps are still fine as far as I know. ProLock sent a thicker replacement cap. ?The reason I mention this is it would be better to get the modified thicker design. ?When I get to the office I will search for the emails with ProLock, I think there may have been a drawing that I could share.
toggle quoted message
Show quoted text
Thanks joe!! ?Was it a stock model - did you have to order anything special ? ? I don’t mind ordering 4 And seeing if others are interested?
Get
Michal,
How was the class? ?I wish I was still woodworking just so I would have an excuse to go hang out with Ultimate Joe in Ouray, CO.
When I ordered the ProLock 1 1/4” spindle caps we had to order 4 to make a minimum custom order.
I ordered them directly from ProLock and picked them up at LIGNA that year.?
Hey Folks – I had seen a thread about the ProLock spindle locks and know that Joe D had ordered his for a 1 ?” shaper spindle.? I have a K700Z and saw these recently at the Rangate joinery class and was hoping to get one.?? Can anyone direct me to a source??
I did try to see if I could message Joe but could not figure out how to do that on the forum -?
?
Thanks
?
Michael
?
704-783-7154
?
